Jabra GO 6470 - Manual (Page 35)

35
en
g
li
sh
Jabra GO 6470 User manUal
6.6 contRolling the SPeakeR voluMe and MicRoPhone
the headset features a touch panel that is similar to the touch pad included with many laptop computers. Use it
to adjust the volume you hear in your headset and to mute/unmute the microphone.
- slide your finger up the touch panel (away from your mouth) to increase the volume.
- slide your finger down the touch panel to decrease the volume.
- double-tap on the touch panel to mute or unmute the microphone.
Figure 40:
2 x
using the volume strip and mute control
you can also control the volume and mute functions using the touchscreen. see the section “Call options” for
more.
Note:
- Unique double-tones in the headset indicate that you have reached maximum or minimum volume.
see also the section “headset signal tones”
- a unique double-tone indicates that microphone muting is active. this signal repeats occasionally
until you unmute the microphone.
If you end the call while the microphone is muted, it is automatically umuted the next time you place
or answer a call.
- the speaker volume adjustment screen is shown automatically on the base if you use the headset’s
touch panel to adjust the volume. see the section “Call options” for more.
6.7 Switching Between youR Phone and headSet
It is possible to enable or disable the headset without interrupting your current call.
Desk Phones
to go from desk-phone handset to your headset:
1. If necessary, set the desk phone as the current target for your headset (see also Section 6.2: the target Phone
Concept.)
2. activate the audio link to the headset by doing one of the following: tap the headset’s multifunction button;
touch the call icon on the touchscreen; or lift the headset from the Jabra GO base (if enabled, see Section 8.8:
headset Docking-operation).
3. listen to hear if you are now connected through the headset. If you are not connected, then you may need to
press the desk-phone headset button. see also your desk-phone documentation.
4. place the handset on your desk, but do not hang up, because this will terminate your call.
to go from headset to desk-phone handset:
1. lift the handset to your ear.
2. do one of the following:
- If you are using a traditional phone without a headset button or electronic hookswitch, then deactivate the
audio connection to your headset by tapping the headset multifunction button, docking the headset in its
cradle on the Jabra GO base or touching the end-call icon on the touchscreen. (this applies also if you are
using a Gn1000 remote handset lifter.)
- If your desk phone has a dedicated headset port and/or electronic hookswitch, then please see your desk-
phone documentation for details. In some cases, you must press a button on your desk phone, while in
others it will be automatic. also, some phones may terminate the connection if you deactivate the audio
link to the headset (e.g., by tapping its multifunction button or docking it in its charge cradle), while others
may require you to do this before you can speak on the handset. experiment to find out what works best
for you.