JVC KD-MX3000 - Manual (Page 30)

30
3
Select the character set you want while “ ”
is flashing.
Each time you press the button, the character set changes
as follows:
4
Select a character.
About the available characters, see page 31.
5
Move the cursor to the next (or previous)
character position.
6
Repeat steps 3 to 5 until you finish inputting the name.
7
Press the button while the last selected
character is flashing.
The input name is stored in memory.
To erase the input characters
Insert spaces using the same procedure described above.
Note:
When you assign a name to the 47th disc, “NAME FULL” appears on the display. (In this case, delete
unwanted names before assignment.)
Capital letters Small letters
Numbers and symbols
SSM
SEL
DISP
EN 21-32 KD-MX3000 [J]/F 98.10.19, 6:52 PM 30