JVC RX-6030VBK - Manual (Page 38)

36
To change the transmission signals for
operating a DVD player
1 Press and hold STANDBY/ON DVD.
2 Press DVD.
3 Enter manufacturer’s codes using buttons
1 – 9, and 0.
4 Release STANDBY/ON DVD.
Now, you can use the following buttons on the DVD player.
3 Start playback.
7 Stop playback.
¢ Skip to the beginning of the next chapters.
4 Return to the beginning of the current (or previous)
chapters.
8 Pause playback. To release, press 3.
DVD menu operations
After pressing DVD (or DVD MULTI*),
you can use the following buttons for
DVD menu operations:
* RX-6030VBK and RX-6032VSL only.
MENU Display or hide the menu screen.
5 5 5 5 5/∞ ∞ ∞ ∞ ∞/3 3 3 3 3/2 2 2 2 2 Select an item on the menu screen.
ENTER (10) Enter a selected item.
5 Try to operate your DVD player by pressing
STANDBY/ON DVD.
When your DVD player turns on or off, you have entered
the correct codes.
Manufacturers’ codes for DVD player
Manufacturer Codes
JVC 01*
Panasonic 02
Philips 04
Pioneer 03
Sony 05
Toshiba 06
Yamaha 07
* “01” is the initial setting.
Manufacturers’ codes are subject to change
without notice. If they are changed, this remote
control cannot operate the equipment.
Operating Other Manufacturers’ Video Equipment
TEST
MENU
ENTER LEVEL
RETURN
SURR R SURR L
SUBWFR CENTER
FRONT R FRONT L
100
1
4
7/P
10
2
5
8
0
3
6
9
10
TA/NEWS/INFO
To change the transmission signals for
operating a VCR
1 Press and hold STANDBY/ON VCR.
2 Press VCR.
3 Enter manufacturer’s codes using buttons
1 – 9, and 0.
4 Release STANDBY/ON VCR.
Now, you can perform the following operations on the
VCR.
STANDBY/ON VCR Turn on or off the VCR.
VCR CH +/– Change the channels.
After pressing VCR, you can perform the following
operations on the VCR:
3 Start playback.
FF Fastwind a tape.
REW Rewind a tape.
7 Stop playback or recording.
8 Pause playback. To release, press 3.
REC PAUSE Press this button to enter recording
pause.
Then press
3 to start recording.
Note:
Refer also to the manual supplied with your VCR.
5 Try to operate your VCR by pressing
STANDBY/ON VCR.
When your VCR turns on or off, you have entered the
correct codes.
If more than one code is listed for your brand of VCR,
try each one until the correct one is entered.
Manufacturers’ codes for VCR
Manufacturer Codes
JVC 01*, 02, 03
Emerson 10, 22
Gold Star 11
Hitachi 04
Mitsubishi 12
NEC 21
Panasonic 07, 13
Philips 09
RCA 05, 06
Samsung 20
Sanyo 17, 18, 19
Sony 14, 15, 16
Zenith 08
* “01” is the initial setting.
28-39_RX-60_5030[J]f 02.11.28, 13:48 36