JVC RX-6030VBK - Manual (Page 52)

6
English
Getting Started
7 Speaker layout diagram Connecting the Speakers and Subwoofer
You can connect five speakers—a pair of front speakers, a
center speaker, and a pair of surround speakers—and a
subwoofer.
CAUTION:
Use speakers with a SPEAKER IMPEDANCE as indicated by the
speaker terminals.
7 Connection diagram
7 How to connect speaker cords
For each speaker, connect the (+) and (–) terminals on the
rear panel to the (+) and (–) terminals marked on the
speakers.
1 Twist and remove the insulation at the end of
each speaker cord.
2
Open the terminal (1), then insert the speaker
cord (2).
3
Close the terminal.
1
2
1 2 3
+
–
+
–
Left front
speaker Subwoofer
Center
speaker
Left
surround
speaker
Right
surround
speaker
Right front
speaker
CENTER
SPEAKER
SURROUND
SPEAKERS
RIGHT
LEFT
FRONT
SPEAKERS
RIGHT
LEFT
CAUTION :
SPEAKER IMPEDANCE
8
16
+
–
+
–
+
–
+
–
To left
front speaker
To right surround speaker
To center speaker
To right front speaker
To left surround
speaker
SUBWOOFER
OUT
Powered
subwoofer
To subwoofer
input
7 How to connect the subwoofer
Connect the input jack of a powered subwoofer to the
SUBWOOFER OUT jack on the rear panel, using a cable with
RCA pin plugs (not supplied).
• Refer also to the manual supplied with your subwoofer.
By connecting a subwoofer, you can enhance the bass or
reproduce the original LFE signals recorded in the digital
software.
Since bass sound is non-directional, you can place a
subwoofer wherever you like. Normally place it in front of
you.
After connecting the front, center, surround speakers and/
or a subwoofer, set the speaker setting information properly
to obtain the best possible Surround effects with your
listening conditions. For details, see pages 15 and 16.
• “NO” for the subwoofer, “LARGE” for the front speakers,
and “SMALL” for the center and surround speakers are
initial settings.
EN01-10_RX-60_5030[C]f 02.12.24, 18:40 6