JVC RX-6030VBK - Manual (Page 61)

15
English
4
Turn MULTI JOG dial to adjust the selected
item.
Select “SUBWOOFER YES” if a subwoofer is connected.
Ex.: When “SUBWOOFER YES” is selected.
5
Press EXIT.
To adjust other items, repeat steps 2 to 5.
To finish the setting, go to step 6.
6
Press EXIT again.
The receiver exits from the basic setting mode.
Setting the Speaker Information
“NO” for the subwoofer, “LARGE” for the front speakers, and
“SMALL” for the center and surround speakers are initial
settings.
To get best possible sound, change the subwoofer and
speaker settings to fit your listening conditions.
7 Subwoofer information—SUBWOOFER
Register whether you have connected a subwoofer or not.
YES Select this when you have connected a subwoofer.
You can adjust the subwoofer output level
(see page 21).
NO Select this when you have not connected or have
disconnected a subwoofer.
7 Speaker size—FRNT (Front) SPEAKERS, CNTR (Center)
SPEAKER, SURR (Surround) SPEAKERS
Register the sizes of all the connected speakers.
• When you change your speakers, register the information
about the speakers again.
LARGE Select this when the size of the cone speaker unit
built in your speaker is greater than 12 cm
(4
3 / 4 inches).
SMALL Select this when the size of the cone speaker unit
built in your speaker is smaller than 12 cm
(4
3 /
4
inches).
NONE Select this when you have not connected a
speaker. (Not selectable for the front speakers)
Notes:
• If you have selected “NO” for the subwoofer setting, you can only
select “LARGE” for the front speaker setting.
• If you have selected “SMALL” for the front speaker setting, you
cannot select “LARGE” for the center and surround speaker settings.
Basic Settings Using MULTI JOG Dial
After connecting and placing speakers, you need to make
basic settings for the following items according to your
listening conditions.
• Speaker information (see the next column and page 16)
• Digital input terminal sources (see page 16)
• RX-6030VBK and RX-6032VSL only:
Video input terminal type (see page 16)
7 Operating buttons
Buttons To do
SETTING Enter the receiver into the basic setting
mode.
MULTI JOG • Select an item to adjust after pressing
SETTING.
• Adjust the selected item after pressing
SET.
SET Determine the item to adjust.
EXIT Exit from the basic setting mode or return
to the previous step.
7 Operating procedure
Ex. Setting the subwoofer information
Before you start, remember...
There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step
1 again.
1
Press SETTING.
The last selected item appears on the display.
2
Turn MULTI JOG dial to select an item you
want to adjust.
* RX-6030VBK and RX-6032VSL only.
3
Press SET.
The current setting of the selected item appears on the
display.
Ex.: When “SUBWOOFER” is selected.
Basic Settings
SUBWOOFER FRNT SPEAKERS CNTR SPEAKER
SURR SPEAKERS DISTANCE UNIT FRNT DISTANCE
CNTR DISTANCE SURR DISTANCE CROSSOVER
LFE ATTENUATE D_COMPRESSION DIGITAL IN
VIDEO IN DVD* (back to the beginning)
O O
O
O O
O O
O
O O O
O O O
VIDEO IN VCR*
RY
DIMMER
INPUT DIGITAL
SETTING MULTI JOG
SET
ADJUST
EXIT
INPUT ANALOG
INPUT ATT
SETTING
MULTI JOG
SET
ADJUST
EXIT
EN11-17_RX-60_5030[C]f 02.12.24, 18:40 15