SMC Networks SMC2804WBR V.2 - Manual (Page 13)

Installing the Wireless Barricade™ g Router
10
Attach to Your Network Using Ethernet Cabling
The four LAN ports on the Wireless Barricade™ auto-negotiate
the connection speed to 10 Mbps Ethernet or 100 Mbps Fast
Ethernet, and the transmission mode to half duplex or full duplex.
Use twisted-pair cable to connect any of the four LAN ports
on the Wireless Barricade™ to an Ethernet adapter on your
PC. Otherwise, you can cascade any of the LAN ports on the
Wireless Barricade™ to an Ethernet hub or switch, and then
connect your PC or other network equipment to the hub or
switch. When inserting an RJ-45 plug, be sure the tab on
the plug clicks into position to ensure that it is properly seated.
Warning: Do not plug a phone jack connector into any RJ-45
port. This may damage the Wireless Barricade™.
Instead, use only twisted-pair cables with RJ-45
connectors that conform with FCC standards.
Figure 3. Making the LAN Connections