SINGER 127-3 & 128-3 - Manual (Page 10)

127-3 & 128-3
Table of Contents Previous Page | Next Page
10
To Prepare for Sewing
With the left hand hold the end of the needle
thread, leaving it slack from the hand to the
needle. Turn the balance wheel over toward
you until the needle moves down and up
again to its highest point thus catching the
bobbin thread, draw up the needle thread and
the bobbin thread will come up with it through
the hole in the throat plate (see Fig. 12) Lay
both threads back under the presser foot and
close the slides.
FIG. 12. DRAWING UP THE BOBBIN THREAD
To Commence Sewing
Place the material beneath the presser foot,
lower the presser foot and commence to sew,
turning the balance wheel over toward you.
Remove the Work
Let the thread take-up lever rest at its highest
point, raise the presser foot and draw the fab-
ric back and to the left, pass the threads over
the thread cutter (A, Fig. 12) and pull down
lightly to sever them. Leave the ends of the
threads under the presser foot.