SINGER 127-3 & 128-3 - Manual (Page 25)

127-3 & 128-3
Table of Contents Previous Page | Next Page
25
To Adjust the Ruffler for
Group Plaiting and Gathering
The ruffler can be adjusted for group plaiting
by lifting the adjusting lever (E Fig. 32) and
moving it to the right so that the top of the
projection (D, Fig. 32) engages the small slot
indicated by the star on the adjusting lever.
This should be done at the points where you
wish to make the space between the plaits.
The ruffler will then stop and plain stitching
will be made. When the desired space has
been made, adjust the lever (E) so that the
projection (D) enters either the slot marked
"6" or the slot marked "12." By alternately
making groups of plaits and plain spaces, as
shown in Fig. 32, very attractive work can be
produced.
FIG. 32.
To Oil the Ruffler
Occasionally apply a drop of oil to the work-
ing parts of the ruffler at each of the places
indicated by arrows in Fig. 32. After oiling,
operate the ruffler on a waste piece of materi-
al to prevent the oil soiling the work. If the ruf-
fler does not plait evenly, a drop of oil may
remedy the trouble.
SINGER Needles should be used
in SINGER Machines.
These Needles and their Containers
are marked with the Company's Trade Mark
"SIMANCO"*
Needles in Containers marked
"FOR SINGER MACHINES”
are NOT SINGER made Needles.