SINGER 127-3 & 128-3 - Manual (Page 23)

127-3 & 128-3
Table of Contents Previous Page | Next Page
23
FIG. 28.
To Make a Ruffle and
Sew it to a Garment in One Operation
Insert the material to be ruffled between the
two blue blades, as shown in Fig. 28, follow-
ing the line 2, in Fig. 26. Place the garment to
which the ruffle is to be attached, under the
separator blade, following the line 1, in Fig.
26. Proceed the same as for gathering.
The edge of the ruffled seam can be bound
by using the builder.
To Ruffle and Sew on
a Facing in One Operation
Insert the material to be ruffled between the
two blue blades, following the line 2, in Fig,
26.. Place the garment to which the ruffle is
to be attached, under the separator blade,
following the line 1, in Fig. 26. Place the
material for the facing over the upper blue
blade, as shown in Fig. 29, following the line
3, in Fig. 26. The facing may be straight or
bias material. If the facing is to be on the right
side of the garment, place the garment and
the ruffle so that the wrong sides are togeth-
er. If the facing is to be on the wrong side,
place the right sides of the garment and the
FIG. 29.