SINGER 127-3 & 128-3 - Manual (Page 7)

127-3 & 128-3
Table of Contents Previous Page | Next Page
7
To Thread the Shuttle
Hold the shuttle between the thumb and fin-
gers of the left hand as shown in Fig. 7.
Place the bobbin into the shuttle with the
thread drawing toward the right from the side
of the bobbin nearest you, as shown in Fig. 7.
Place the forefinger of the left hand on the
end of the bobbin and draw the thread down-
ward into the long slot in the shuttle as far as
it will go, as shown in Fig. 8.
Then draw the thread straight upward and
under the tension spring as shown in Fig. 9,
until the bobbin begins to unwind.
FIG. 7
FIG. 8 FIG. 9