Sony MK7807V1 - Manual (Page 105)

Applicable Models
PFV-HD50A HD Digital Video Interface Unit
Specifications
Inputs/outputs
Video input:
DIGITAL IN connector (BNC type) (1)
HD component serial digital video
signal conforming to SMPTE292M, 1.5
Gb/s (BTA S-004B)
Input impedance:
75 Ω , unbalanced
Return loss:
15 dB minimum (5 to 750 MHz)
10 dB minimum (750 MHz to 1.5 GHz)
Cable length:
100 m max. (when using 5C-FB coaxial
cable)
Data rate:
1.4835 GHz or 1.485 GHz
Video outputs:
ANALOG OUT Y/G, PB/B, and PR/R
connectors (BNC type) (2 sets)
HD component analog video signal
(SMPTE240M/274M (59.94 or 60.00 Hz)
standard)
Output impedance:
75 Ω , unbalanced
Output level:
1.0 Vp-p ؎1% (Y, R, G, B)
0.7 Vp-p ؎1% (PB, PR)
Frequency characteristics:
؎0.3 dB (60 Hz to 20 MHz)
؎0.7 dB (20 to 30 MHz)
Sync signal:
ANALOG OUT SYNC connector (BNC
type) (1)
Conforming to SMPTE240M/274M
(59.94 or 60.00 Hz) standard.
Impedance:
75 Ω , unbalanced
Level:
0.6 Vp-p ؎1%
Delay time:
1000 ns or less
ISR output information:
Status messages: 2 items
Setup messages: 3 items
General
Power requirements:
+5.0 V DC: 1.4 A, -5.0 V DC: 700 mA
(Supplied from the PFV-HD300A/HD50A
Interface Unit)
Power consumption:
Approx. 10 W
Operating temperature:
5 to 40 °C (41 to 104 °F)
Dimensions
Board (H x W):
194 x 310 mm
(7 3/4 x 12 1/4 inches)
Connector panel (H x D x W):
218 x 98 x 25 mm
(8 5/8 x 3 7/8 x 1 inches)
Mass
Board:
Approx. 700 g (1 lb 8 oz)
Connector panel:
Approx. 200 g (7 oz)
HD SERIAL DIGITAL
VIDEO INPUT
D/A
HD COMPONENT ANALOG
VIDEO OUTPUT
G / B / R
or
Y / P B / P R
HD COMPONENT ANALOG
VIDEO OUTPUT
G / B / R
or
Y / P B / P R
HD ANALOG SYNC OUTPUT
The HKPF-102 HD D to A converter board converts an
HD component serial digital video signal to an HD
component analog video signal. The input is switchable to
accept either a Y/PB /PR or RGB format signal. Two sets
of outputs are provided. The HKPF-102 automatically
switches between 1080 and 1035 active lines and 59.94
or 60.00 Hz field rate operation.
Features
* Converts an HD component serial digital signal to an HD
component analog signal * Supports ISR
The HKPF Series function boards install in the PFV-HD Series Interface Units
together with the BKPF Series function boards.
103
Interface Processor D Series
Inter
face Pr
ocessor D Series
HKPF-102
HD D to A Converter Board
Rear Panel
*SGC_0099-0116 02.3.16 5:04 PM Page 103