Siemens Gigaset C340 - Manual (Page 22)

21
SMS (Text Messages)
Gigaset C340 / Im-eng / A31008-M1621-R101-1-7619 / sms_BRD_neutral.fm / 23.11.04
Setting up an SMS centre
Entering/editing an SMS centre
¤
Before you make a new application
or before deleting preset phone num-
bers, find out about your service pro-
vider's range of services and special
offers.
§Menu§
¢
SMS
¢
Settings
¢
Service
Centres
q Select an SMS centre (e.g. SMS
Centre No. 1 ) and press §OK§ .
The §Menu§ offers the following options:
Active Send Service Centre
Activate an SMS centre ( ‰ = on) if you
want your text messages to be sent via
this SMS centre. With SMS centres 2 to
5 the setting applies to the next mes-
sage only.
SMS
Enter the number of the SMS service
and press §OK§ .
E-mail
Enter the number of the email service
and press §OK§ .
Sending text messages via another
SMS centre
¤
Activate the SMS centre (2 to 5) as the
active send service centre (page 21).
¤
Send the message.
This setting only applies to the next mes-
sage you send. Subsequent messages will
be sent with SMS Centre 1 again.
SMS and PABX's
u You can only receive a text message
when the Caller ID (CLIP) is forwarded
to the extension of the PABX. The
CLIP of the number of the SMS centre is
evaluated in your Gigaset.
u Depending on your PABX, you may
have to put the access code (outside
line code) before the number of the
SMS centre.
If in doubt, test your PABX by sending
two text messages to your own
number, one with the access code and
one without it.
u When you send messages, your sender
number may be sent without your
extension number. The recipient can-
not reply to you directly in this case.
Text messages can only be sent and
received through ISDN exchanges with
the MSN number assigned to your base.
Activating/deactivating the
SMS function
When you deactivate the SMS function
you will not be able to receive SMS mes-
sages as text messages and your phone
will no longer send SMS messages.
Settings which you have made for sending
and receiving text messages (the numbers
of SMS centres) and any entries in the
incoming message list and the draft mes-
sage list will be retained even after the
function is deactivated.
§Menu§
5 4 O 2 L
Q
§OK§ Deactivate SMS function.
Or:
1
§OK§ Activate SMS function (factory
setting).
SMS Troubleshooting
Error codes when sending
If a text message cannot be sent for a long
period of time, it is moved to the incoming
messages list with the Status Error XX.
E0 Permanent restriction of Caller ID is acti-
vated (CLIR) or Caller ID has not been ena-
bled.
FE Error occurred during message transfer.
FD Error while connecting to the SMS centre,
see Self Help.