Siemens Gigaset C340 - Manual (Page 27)

26
Using several handsets
Gigaset C340 / Im-eng / A31008-M1621-R101-1-7619 / registration.fm / 23.11.04
Barging-in to an external call
You are conducting an external call. An
internal party can 'barge in' to this call and
take part in the conversation. All the par-
ties are made aware of the ‘barge-in’ by a
signal tone.
Requirement: The
Listening in function is
activated.
Activating/deactivating internal barge-
in
Menu§
¢
Handset
¢
Base
¢
Additional
Features
¢
Listening in
a Long press (idle status).
Internal barge-in
The line is busy with an external call. You
see a message to this effect on your dis-
play, and you want to barge in on the
external call.
c
Press the talk key long.
You are linked into the call. All parties hear
a signal tone.
Ending barge-in
a Press the end call key.
All parties hear a signal tone.
If the first internal user presses his end call
key a, the other handset that has barged
in and the outside caller remain con-
nected.
Changing the name of a handset
Handsets are automatically given the
names "INT 1", "INT 2" etc. when they are
registered. You can change these names.
The name can be up to 10 characters long.
The changed name is displayed in the list
of every handset.
INT Open list of internal users.
s Select handset.
§Menu§ Press the control key.
s Select Change Handset .
~ Enter the name.
§OK§ Press the control key.
Changing a handset's
internal number
A handset is automatically allocated the
lowest available number when it is regis-
tered. If all of the numbers have been allo-
cated, then number 6 is overwritten if this
handset is in idle status. You can change
the internal number of all registered hand-
sets (1–6).
INT Open list of internal users.
s Select handset.
§Menu§ Press the control key.
s Select Edit Handset Number .
~ Enter a number.
§OK§ Press the control key.
a Long press (idle status).
You will hear the error tone if an internal
number has been allocated twice.
¤
Repeat the process with an available
number.
Using a handset as a
room monitor
With this function, a previously stored
internal or external number is called when
a set noise level in the room is reached.
The room monitor call to an external
number stops after approx. 90 seconds.
The room monitor call to an internal
number (handset) stops after approx.
3 minutes (depending on the base).
During the call, all keys are locked except
the end call key. The room monitor
function remains active after you end the
call. It must be activated again if the hand-
set has been switched off.