Sharp VL-NZ100S - Manual (Page 24)

Preparation
Preparation
13
Inserting and Removing
a Card
You can use an SD Memory Card or a
MultiMediaCard for storing still images.
Inserting
1
Make sure that the Power switch is set
to OFF.
2
Slide the card slot cover release and
open the card slot cover in the direction
of the arrow.
3
Insert a card into the slot as shown
below, and push it in as far as it will go.
4
Close the card slot cover.
Removing
Perform steps 1 and 2 above, push the card
(1) and pull the card straight out (2) as shown
below.
Notes:
• You can use only the SD Memory Card or the
MultiMediaCard (see page 71).
• The supplied card is preformatted for immediate
use.
• See pages 73 and 74 for more information on the
cards intended for use with this camcorder.
Caution:
• Do not remove the card from the camcorder
while recording data on the card (S indicator
flashes during recording). This may delete the
recorded image or damage the card.
About the write-protect switch
SD Memory Card has a write-protect switch.
When the switch is set to the locked position,
you cannot record/delete data or format the
card. Set it to the unlocked position to record/
delete data or format the card.
Card slot cover release
Label
Clipped corner
Back view
Locked position
Unlocked position
Write-protect
switch
VL-NZ100H-009-018 02.2.14, 9:58 AM 13