Sharp UX-B800 - Manual (Page 13)

Installing the Print Cartridge
11
1. Installation
2 Remove only the
tape from the new
cartridge.
•
Make sure all
tape is removed.
•
CAUTION!
DO NOT touch
the gold
contact area
on the
cartridge.
3 Make sure the cartridge holder is in
the position shown. Place your
fingers on top of the holder and
open the holder release.
If the display shows [PRINTER ERROR]
or [PRINTER ERROR/CHECK PAPER],
open the cover and check for jammed
paper. Remove any jammed paper (see
page 67) and close the cover.
4 Insert the new print cartridge ( ➊).
Close the holder (
➋), making sure it
clicks into place.
•
CAUTION! DO NOT touch the gold
contact area or pull on the cable.
•
If you are replacing the cartridge,
remove the old cartridge. If you are
going to use the old cartridge again,
place it in an air-tight container
(containers for this purpose can be
purchased at most office supply
stores).
1
2
5 Close the cover, pressing firmly on
both front corners.
Displa y: [CHANGE CARTRIDGE]/
[1=NEW, 2=OLD] .
6 Press ( NEW ) if the cartridge
you installed is new.
Display:
[NEW CARTRIDGE?] /
[OK:PRESS START]
Press ( OLD ) if the cartridge
you installed is old.
7 Press .
If you selected " OLD " in the
previous step, this completes the
installation procedure. (Note: If you
find that print quality is not
satisfactory, see p. 58 to align the
print cartridge.)
all.book Page 11 Thursday, August 10, 2006 2:22 PM