Sharp UX-B800 - Manual (Page 35)

Sending a Fax: Auto Dialling
33
3. Sending
Fa
x
e
s
•
If you are on a Flash-type PBX and
are dialling out, press , press
to insert a pause, and then
enter the number of the receiving
machine.
•
If you are on a PBX and must dial a
number to dial out, enter the number,
press to insert a pause, and
then enter the number of the
receiving machine.
3 Check the display. If the number
shown is correct, press .
•
If the number is not correct, press
to clear the incorrect digits, and
then re-enter the correct digit(s).
Redial
You can automatically redial the last
number dialled on the machine.
1 Load the document(s).
•
If desired, press to set the
resolution and/or contrast.
2 Press once. Make sure the
display shows the number you wish
to dial.
R
FUNCTION
FUNCTION
STOP
RESOLUTION/
RECEPTION MODE
3 If you are sending a fax, press
. Dialling begins.
If you are making a phone call, lift
the handset. Dialling begins.
Note: If the transmission is
unsuccessful and [DOCUMENT
JAMMED] appears in the display,
remove the document as explained on
page 67.
Automatic redialling
If you use auto dialling (including Direct
Keypad Dialling) to send a fax and the
line is busy, the machine will
automatically make three redial
attempts at intervals of five minutes.
During this time, [RECALLING] will
appear in the display, followed by the
attempt number. You will not be able to
dial any other locations while the
message appears.
♦
To clear the message and stop
automatic redialling, press .
Under certain conditions, automatic
redialling may stop before three
redialling attempts are made.
STOP
all.book Page 33 Thursday, August 10, 2006 2:22 PM