Spalding 211014 - Manual (Page 10)

10
P/N 211014 03/05
SECTION A: ASSEMBLE THE POLES
Wood Scrap
P-2
P-1
5"
(13 cm)
5"
(13 cm)
P-1
P-3
P-2
Pole Identification
Sticker
Pole Identification
Sticker
2.
While maintaining alignment, bounce middle pole section (P-2) into top section (P-1) using a wood scrap
as shown until the top pole no longer moves toward the pole identification sticker on the middle pole.
THE IDENTIFICATION STICKER IS
LOCATED 5" FROM THE END OF
THE POLE. WHEN PROPERLY
POUNDED TOGETHER, THE POLE
SECTIONS SHOULD HAVE A 3-1/2"
MINIMUM OVERLAP, LEAVING 1-
1/2" BETWEEN THE OVERLAPPING
POLE AND THE IDENTIFICATION
STICKER.
CAUTION!
Correctly identify each pole section. 1.
Pole Identification
Sticker
IMPORTANT!
Position middle pole so
that the warning label is
on the same side as the
holes indicated of the
top pole.
TROUGH
Align dimple of top pole section (P-1)
into trough of middle pole section (P-2)
as shown.
IMPORTANT!
HOLE
DIMPLE
Middle Pole
5"
Middle Pole
1-1/2"
ID
STICKER
P-2
P-1