Sony SAVA-D900 - Manual (Page 19)

19
Getting Started
Presetting Radio Stations
You can preset 20 stations for FM and 10 stations for AM.
Before tuning, make sure that you have turned down the
volume to the minimum.
1
Press BAND repeatedly on the remote until the
band you want appears on the front panel display.
Every time you press BAND, FM and AM changes
alternately.
2 Press and hold TUNE + or – until the frequency
indication starts to change, then release.
Scanning stops when the system tunes in a station.
“TUNED” and “ST” (for stereo program) appear on
the front panel display.
3
Press MEMORY.
A preset number appears on the front panel display.
1 2 3
4 5 6
7 8 9
>10 10 0
BAND
PRESET +/– TUNE +/–
ENTER
MEMORY
4 Press PRESET + or – to select the preset number you
want.
5
Press ENTER.
The station is stored.
6
Repeat Steps 1 to 5 to store other stations.
To tune in a station with a weak signal
Press TUNE + or – repeatedly in Step 2 to tune in the
station manually.
To change the preset number
Start over from Step 1.
To change the AM tuning interval
The AM tuning interval is factory set to 10 kHz.
To change the AM tuning interval, tune in any AM station
first, then turn off the power. While holding down the
SUBWOOFER MODE button, turn the power back on.
When you change the interval, AM preset stations will be
erased.
To reset the interval, repeat the same procedure.