Sony SAVA-D900 - Manual (Page 67)

67
Additional Information
, The protective device on the system has been
activated because of a short circuit. Turn off the
system, eliminate the short-circuit problem and
turn on the power again.
, The audio connecting cord is damaged. Replace it
with a new one.
, The system is in pause mode or in Slow-motion
Play mode. Press H or N on the remote to
return to normal play mode.
, Fast forward or fast reverse is performed. Press
H or N to return to normal play mode.
, Check the speaker settings (page 16).
The left and right sounds are unbalanced or
reversed.
, Check that the speakers and components are
connected correctly and securely.
, Adjust front balance parameter in the LEVEL
menu (page 18).
Severe hum or noise is heard.
, Check that the speakers and components are
connected securely.
, Check that the connecting cords are away from a
transformer or motor, and at least 10 feet (3 meters)
away from a TV set or fluorescent light.
, Move your TV away from the audio components.
, The plugs and jacks are dirty. Wipe them with a
cloth slightly moistened with alcohol.
, Clean the disc.
The sound loses stereo effect when you play a
VIDEO CD or a CD.
, Set “AUDIO” to “STEREO” in the Control Menu
display (page 41).
, Make sure you connect the system appropriately.
The surround effect is difficult to hear when you
are playing a Dolby Digital sound track.
, Make sure the sound field function is on (page 22).
, Check the speaker connections and settings (page
10).
, Depending on the DVD, the output signal may not
be the entire 5.1 channel but monaural or stereo
even if the sound track is recorded in Dolby Digital
format.
The sound comes from the center speaker only.
, Depending on the disc, the sound may come from
the center speaker only.
No sound is heard from the center speaker.
, Make sure the sound field function is on (page 22).
, Select a sound field containing the word “cinema”
or “virtual” (page 22).
, Adjust the speaker volume (page 17).
No sound or only a very low-level sound is heard
from the rear speakers.
, Make sure the sound field function is on (page 22).
, Select a sound field containing the word “cinema”
or “virtual” (page 22).
, Adjust the speaker volume (page 17).
Operation
There is noise inside the system.
, It is not an error. You may hear noise of the DVD
changer when replacing discs or turning on/ off
the system.
The disc tray indicator is on when there is no disc
inside.
, If this is the first time you are using the system, the
disc tray indicators turn on. Press FUNCTION
until “DVD” appears on the front panel, then wait
a while. The indicators will turn off eventually.
, If you pressed the ?/1 switch to turn off the
system without closing the disc tray, the disc tray
indicator turns on. Wait a while for it to turn off. If
the indicator is still on, press A of DISC 1–DISC 5
to close the disc tray.
Radio stations cannot be tuned in.
, Check that the antennas are connected securely.
Adjust the antennas and connect an external
antenna if necessary.
, The signal strength of the stations is too weak
(when tuning in with automatic tuning). Use
direct tuning.
, No stations have been preset or the preset stations
have been cleared (when tuning by scanning preset
stations). Preset the stations (page 19).
, Press DISPLAY until the frequency appears in the
display.
Continued to the next page