Sony CDX-C7850 - Manual (Page 13)

13
Receiving the memorized
stations
1
Press (SOURCE) repeatedly to select the
tuner.
2
Press (MODE) repeatedly to select the
band.
3
Press the number button ((1) to (10))
where the desired station is stored.
If you cannot tune in a preset
station
Push and release the SEEK/AMS control
up or down to search for the station
(automatic tuning).
Scanning stops when the unit receives a
station. Push the SEEK/AMS control up or
down repeatedly until the desired station is
received.
Note
If the automatic tuning stops too frequently, press
(SHIFT), then press (4) (PLAY MODE) repeatedly
until “Local” (local seek mode) is displayed. Then
press (5) (n) to select “Local on.” Press (SHIFT).
Only the stations with relatively strong signals will
be tuned in.
Tip
If you know the frequency of the station you want
to listen to, push the SEEK/AMS control up or
down and hold until the desired frequency
appears (manual tuning).
If FM stereo reception is poor
— Monaural Mode
1
During radio reception, press (SHIFT),
then press (4) (PLAY MODE) repeatedly
until “Mono” appears.
2
Press (5) (n) repeatedly until “Mono
on“ appears.
The sound improves, but becomes
monaural (“ST” disappears).
3
Press (SHIFT).
To return to normal mode, select “Mono off”
in step 2 above.
If interference occurs during FM
reception
If there is interference from neighboring
stations, follow the steps below and select
“Narrow”. If interference is not a problem,
select “Wide” to maximize signal reception
and improve sound quality or “IF Auto ”to
switch between “Narrow” and “Wide”
automatically.
1
Press (SHIFT) during FM reception.
2
Press (4) (PLAY MODE) repeatedly until
“IF Auto“ appears.
3
Press (5) (n) repeatedly to select
desired setting.
z IF Auto z Wide
Narrow Z
4
Press (SHIFT).
Changing the display item
Each time you press (DSPL), the item changes
as follows:
z Station name* z Frequency
Clock Z
* If the station name is not stored, “NO Name”
appears in the display for one second.
After if you select the desired item, the display
will be automatically change to the Motion
Display mode after a few seconds.
In the Motion Display mode, all the above
items are scrolled in the display one by one in
order.
Tip
The Motion Display mode can be turned off. (See
“Changing the sound and display settings” on
page 17).