Sony STRDG910 - Manual (Page 6)

6 GB
D:\CANNES\SONY_HA\JOB 2007\STR-
DG910\IM_910_CEL\Data_CEL\GB_data\GB03CON_STR-DG910-CEL.fm masterpage: Left
STR-DG910
3-094-430-31 (1)
About the indicators on the display
SBR SBL SB
SW LFE
SP B
L C
SL S
R
SR
SP A ; D EX ; PL IIx ; PL OPT DTS -ES 9 6 / 2 4
COAX HDMI NEO:6
MEMORY RDS ST
MONO D.RANGE
1 2 3 4 5 7 6 8 q; 9
qa qs qh qf qg qd
Name Function
A SW Lights up when sub woofer is
set to “YES” (page 47) and the
audio signal is output from the
SUB WOOFER jacks.
B LFE Lights up when the disc being
played back contains an LFE
(Low Frequency Effect)
channel and the LFE channel
signal is actually being
reproduced.
C SP A/SP B Lights up according to the
speaker system used (page 33).
However, these indicators do
not light up if the speaker output
is turned off or if headphones
are connected.
D ; D (EX) Lights up when the receiver is
decoding Dolby Digital signals.
“; D EX” lights up when the
receiver is decoding Dolby
Digital Surround EX signals.
Note
When playing a Dolby Digital
format disc, be sure that you
have made digital connections
and that INPUT MODE is not
set to “ANALOG” (page 71).
Name Function
E ; PL II (x) Lights up when the Pro Logic II
Movie/Music/Game decoder is
activated.
“; PL IIx” lights up when the
Pro Logic IIx Movie/Music/
Game decoder is activated.
However, these indicators do
not light up if both the center
and surround speakers are set to
“NO” (page 47) and you select a
sound field using the A.F.D.
button.
Note
Dolby Pro Logic IIx decoding
does not function for signals
with a sampling frequency of
more than 48 kHz.
F ; PL Lights up when the receiver
applies Pro Logic processing to
2 channel signals in order to
output the center and surround
channel signals.
However, these indicators do
not light up if both the center
and surround speakers are set to
“NO” (page 47) and you select a
sound field using the A.F.D.
button.
G OPT Lights up when INPUT MODE
is set to “AUTO IN” and the
source signal is a digital signal
being input through the
OPTICAL jack, or when
INPUT MODE is set to “OPT
IN” (page 71).