Sony STRDG910 - Manual (Page 90)

90 GB
D:\CANNES\SONY_HA\JOB 2007\STR-
DG910\IM_910_CEL\Data_CEL\GB_data\GB06OTH_STR-DG910-CEL.fm masterpage: Left
STR-DG910
3-094-430-31 (1)
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver’s memory may remedy
the problem (page 32). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
Reference sections for clearing
the receiver’s memory
Specifications
Amplifier section
Models of area code CEL, CEK
Minimum RMS Output Power
(8 ohms, 20 Hz - 20 kHz, THD 0.09%)
90 W + 90 W 1)
Stereo Mode Output Power
(8 ohms, 1 kHz, THD 1%)
100 W + 100 W 1)
Surround Mode Output Power 2)
(8 ohms, 1 kHz, THD 10%)
140 W per channel 1)
Models of area code E2, TW
Minimum RMS Output Power
(8 ohms, 20 Hz - 20 kHz, THD 0.09%)
85 W + 85 W 1)
Stereo Mode Output Power
(8 ohms, 1 kHz, THD 1%)
100 W + 100 W 1)
Surround Mode Output Power 2)
(8 ohms, 1 kHz, THD 10%)
130 W per channel 1)
Models of area code KR
Minimum RMS Output Power
(8 ohms, 20 Hz - 20 kHz, THD 0.09%)
90 W + 90 W 1) ,
80 W + 80 W 3)
Stereo Mode Output Power
(8 ohms, 1 kHz, THD 1%)
100 W + 100 W 1) ,
90 W + 90 W 3)
Surround Mode Output Power 2)
(8 ohms, 1 kHz, THD 10%)
140 W per channel 1) ,
120 W per channel 3)
1) Measured under the following conditions:
To clear See
All memorized settings page 32
Customized sound fields page 65
Area code Power requirements
CEL, CEK, KR 230 V AC, 50 Hz
E2 240 V AC, 50 Hz
TW 110 V AC, 60 Hz