Star Micronics Dot Impact Printer - Manual (Page 34)

3-26 STAR Command Specifications
Rev. 0.70
ESC N n
[Name] Set bottom margin to n lines
[Code]
ASCII ESC N n
Hexadecimal 1B 4E n
Decimal 27 78 n
[Defined Area] 0 ≤ n ≤ 255 (Not full page length)
[Initial Value] n = 0
[Function] This command sets the bottom margin position to (current line feed amount x n).
The current position when setting is effective from the next page when within the bottom margin.
The bottom margin set using this command is unaffected by changing the form feed amount later.
The set bottom margin is cleared using the “ESC N NUL” or the “ESC O” commands.
The bottom margin setting value must be a value smaller than the length of one page. If a value higher the length of the
page is specified, this setting is ignored.
ESC O
[Name] Cancel bottom margin
[Code] ASCII ESC O
Hexadecimal 1B 4F
Decimal 27 79
[Defined Area] ---
[Initial Value] Not set
[Function] This command clears the bottom margin set using the ESC N (set bottom margin to n lines).
Portion of Paper
Automatically Fed
Bottom Margin
of Line n
Page Length