Sharp MD-MT821 User Manual

Page 12

Advertising
background image

After recording:

Press the

n

/:OFF button while in the stop

mode.

After the track number has been written

on the disc, the power will shut off auto-

matically. (For details about the TOC,

see page 20.)

To remove the MiniDisc:

Turn off the power and move the OPEN

lever in the direction indicated by the arrow.

Recording from a tuner or a CD

(Manual recording)

Manual recordings can be started and

stopped as you like.

1

Place the unit in the recording stand-by

mode. (Perform steps 1 -- 4 in the “Syn-
chro recording” section.)

2 Press the

button.

Recording will start.
To record from a CD, press the

button, and then start playback on the
equipment connected to this unit.

Track numbers can be created while

recording. (Page 17)

To interrupt recording:

Press the

button while recording.

The unit will enter the recording stand-

by mode.

To resume recording, press the

HI but-

ton again.
The track number will be increased by

one each time you interrupt a record-

ing.

can not be made in the

following situations:

Recording on a playback-only MiniDisc

(commercially available music)

If a MiniDisc is protected against acci-

dental erasure (page 9)

about the recording level:

If the recording level is too low, the play-
back sound volume may be too low to
hear well. If it is too high, the playback

sound may be greatly distorted. Since
digitally recorded CDs have a large dy-

namic range (the volume can vary tre-
mendously from very soft to extremely
loud), do not set the recording level any

higher than is necessary.

Precautions when recording:

Do not jar or bump the main unit while

recording. Otherwise, the recording
may be unusable.

Depending on the strength and type 01

playback signal in the original record-
ing, the new recording may not begin
or pause at the correct point when in
the synchro mode. If this happens, try

making a manual recording.

Precautions when inserting a MiniDisc:

To insert a MiniDisc, push on the middle

of the edge of the disc while holding it
parallel to the main unit.

If any resistance is felt, do not try to

force the MiniDisc into the unit. It may

additional more problems. If resistance

is felt, remove the MiniDisc and try re-
loading it.

Notes:

l

Whenever any button is pressed, the

remote control display will light for ap

proximately 7 seconds.

The REC button does not light.

11

Advertising