Sharp MD-MT821 - Manual (Page 38)

Many potential “problems” can be resolved by the owner without calling a service techni-
cian.
If something seems to be wrong with this product, check the following before calling your
authorized SHARP dealer or service center.
PROBLEM CAUSE
Is the AC adaptor disconnected?
The unit does not turn
Is the battery exhausted?
Is the unit in the hold mode?
on.
Has condensation formed inside the unit?
Is the unit being influenced by mechanical shock or by
static electricity?
Is the volume set too low?
No sound is heard from Is the remote control unit or the headphones plugged in?
the headphones. Are you trying to play a with data on it instead of
a containing music?
When the operation
Is the unit in the hold mode?
buttons are pressed, the
Is the battery exhausted?
unit does not respond.
Is the remote control unit plug or the headphone plug
inserted firmly?
Some sounds are Is the battery exhausted?
skipped. Is the unit being subjected to excessive vibration?
The cannot be
Has the track number or character information been
ejected.
written on the disc yet?
Is the unit in the recording or editing mode?
Is the protected against accidental erasure?
Is the unit connected properly to the other equipment?
Recording and editing
Is the AC adaptor unplugged or did a power failure
are impossible.
occur while recording or editing?
Is the unit in the hold mode?
Is an optical signal being output from the external
equipment?
Read the operation manual for the external equipment.
When this product is subjected to stron g 4. Plug the AC adaptor back into the AC
external interference (mechanical shock , outlet and retry the operation.
excessive static electricity, abnormal sup-
ply voltage due to lightning, etc.) or if it is
operated incorrectly, it may malfunction. If
If strange sounds, smell or smoke come out
such a problem occurs, do the following:
of the unit or an object is dropped into the
Unplug the AC adaptor from the AC out-
unit, remove the AC adaptor from the AC
outlet immediatelv and contact a
n 1.
2.
3.
let. authorised SHARP service center.
Remove the battery.
Leave the unit completely unpowered for
approximately 30 seconds.
3 7