Sharp MD-MT821 - Manual (Page 35)

n To eliminate the confirmation
sound
Every time a button is pressed, a “beep”
will be heard in the headphones.
To silence the “beep” sound, do the follow-
While in the stop mode . . .
Hold down the MODE button (Remote
control: move and hold the shuttle switch
at PLAY MODE) until “SET UP” appears.
When you release the button, “BEEP
ON (BEEP 1)” or “BEEP OFF (BEEP
0)" will appear.
ing:
2
Move the shuttle switch to or
1
While in the stop mode . . .
until “EL ON 1 (EL onl)” appears.
To turn off the display backlight
on the remote control unit
Whenever you press a button, the display
will light for about 7 seconds, so that you
can read it in the dark. You can turn off the
backlight.
1
2
3
Hold down the MODE button (Remote
control: move and hold the shuttle switch
at PLAY MODE) until “SET UP” appears.
When you release the button, “BEEP
ON (BEEP 1)” will appear.
Press the MODE button (Remote con-
trol: move the shuttle switch to PLAY
MODE).
“BEEP OFF (BEEP 0)” will appear,
and the confirmation sound will dis-
appear.
To restore the confirmation sound, se-
lect “BEEP ON (BEEP 1)“.
Press the button.
The normal display will reappear.
3
Press the MODE button (Remote con-
trol: move the shuttle switch to PLAY
MODE).
Whenever the button is pressed
EL ON 1 (EL onl) EL ON 2 (EL on2)
OFF (EL off)
When “EL OFF (EL off)” is selected, the
backlight will go out.
To turn the backlight on:
“EL ON 1 (EL on1 )”
When any button is pressed, the backlight
will remain lit for about 7 seconds.
“EL ON 2 (EL on2)”
When the rechargeable battery or alkaline
battery is used, the backlight will remain lit
for about 7 seconds.
When the AC adaptor or a car adaptor is
used and the power is turned on, the back-
light will always be lit.
(However, the brightness may be a little less
than when using the battery.)
4
Press the button.
The normal display will reappear.
34