Sharp MD-MT821 User Manual
Page 34
n Checking the remaining amount
of batterv charged
The remaining amount of battery charge
is shown by the battery indicator
during operation.
Battery indicator
How
to read
the
battery indicator
When the battery is Charging is
completely charged needed.
When the battery needs charging, it is
impossible to start recording or editing.
When the battery is completely discharged,
the whole battery indicator will flash. Re-
charge the battery or replace the alkaline
battery with a new one.
When the battery has run completely out,
" B a t t EMPTY’ (main unit) and “Lo BATT
(remote control unit) will appear. Then, the
power will be disconnected automatically.
Notes:
When usina the unit with an alkaline bat-
tery or a rechargeable battery, the battery
indicatorwill notcorrectlydisplaythe remain-
ing capacity for approximately 20 seconds
after the power has been turned on.
When the AC adaptor included with this unit
or a separately available car adaptor is
used, the battery indicatorwill not be shown.
The number of bars shown in the battery
indicator may increase or decrease, de-
pending on the operation being performed.
This is normal.
When the rechargeable battery and the al-
kaline battery are used at the same time,
the rechargeable battery is used first, then
the alkaline battery.
Since the battery indicator shows the re-
maining amount of the particular battery
being used, the number of bars will in-
crease when the unit switches to the al-
kaline battery.
To
prevent the unit from beina
operated by mistake
To avoid accidental operation of the unit,
use the hold function.
Move the HOLD switch to the safety
position (direction indicated by the arrow).
When the unit is in the hold mode, press-
ing the buttons will have no affect.
To cancel the hold mode, move the
HOLD switch away from the safety po-
sition (the opposite direction of the ar-
row).
remote control unit or
from either the
the main unit.
Cannot be operated
from either the
remote control unit or
Hold Hold
the main unit.
If the hold function is active while the power
is turned off, the power cannot be turned
on by mistake and the battery will not be
accidentally drained.
33