Sony RM-VL600T - Manual (Page 15)

15
Programming remote control signals to
the Component Select buttons and
System Control buttons
You can “teach” one operating procedure to a
Component Select button and System Control
buttons, so that when you press the Component
Select button and System Control buttons, the
operation is also automatically done.
For example, if it is necessary to switch the input
selection of an amplifier to DVD when you use a
DVD player, “teach” an input select signal to the
DVD button. After “learning,” the input selection of
an amplifier is automatically switched to DVD just
by pressing DVD. (For this operation, the amplifier
should first be turned on.)
Example: To “teach” the DVD input remote
control signal of your amplifier to the DVD
Component Select button of the Commander
1
Follow Steps 1 to 2 (page 12).
2
Press and hold the Component Select
button for the component whose signals
are to be “learned” for over 3 seconds.
DVD
To teach signals to the SYSTEM CONTROL
buttons, press and hold the desired SYSTEM
CONTROL button for over 3 seconds.
Both the SET indicator and the selected
Component Select button light up.
SET
SAT DVD TV CBL
TAPE CD VCR AMP
When you “teach” signals to the SYSTEM
CONTROL buttons, only the SET indicator
lights up.
When the SET indicator lights up, you can
release the Component Select button. The SET
indicator flashes and the selected Component
Select button lights up (Learning function
standby).
SET
SAT DVD TV CBL
TAPE CD VCR AMP
When you “teach” signals to the SYSTEM
CONTROL buttons, you can release the SYSTEM
CONTROL button when the SET indicator lights
up. The SET indicator lights up, but the SYSTEM
CONTROL button does not light up.
If another signal has already been
“learned” by that button
The SET indicator flashes twice, and the Commander
takes no action, returning to its state after SET was
pressed and held in Step 2. Either “teach” to another
free button, or clear the already “learned” function
(page 16) and start over from the beginning.
3
Press and hold the button on the other
remote control, until the SET indicator
lights and all the Component Select
buttons flash again.
During data transfer, only the SET indicator
stays lit, and the Component Select button turns
off.
If the SET indicator flashes five times
It means that “learning” is incomplete. Repeat Steps 2
and 3.
4
Repeat Steps 2 and 3 to “teach” remote
control signals to other buttons.
5
Press SET to finish “learning.”
Notes
• If you do not perform Learning steps within 20 seconds
at any point during the process, Learning mode ends.
• If you do not perform Step 3 within 10 seconds after Step
2, the Learning procedure returns to Step 1. Repeat from
Step 2 while the Component Select button is lit.
To cancel “learning,” press SET.
Continued