Sony RM-VL600T - Manual (Page 20)

20
SAT DVD TV CBL
TAPE CD VCR AMP
SAT DVD TV CBL
TAPE CD VCR AMP
Volume control setting complete.
To set only the audio components’ volume
controls to AMP
Press 2 – while holding % pressed.
Only AMP lights up when you press these
buttons, and then turns off when you release
them.
Press and while holding 2 –, press %.
Visual components are:
TV, video cassette recorder, analogue cable
box, satellite tuner, DVD player
Audio components are:
CD player, MD player, cassette deck, amplifier
To cancel setting, press SET.
Note
If you used the Learning function to programme the 2 +/
– or % buttons to send a signal to a component, the
procedure above will not change the function of the 2 +/–
and % buttons.
Adding an Extra Function to the
Component Select Buttons
Programming the Power-On command of
the selected component just by pressing
that Component Select button (for Sony
components only)
When a code number of a Sony component is set to
a Component Select button, the Power-On signal is
automatically programmed to the button. You can
select the desired component and power it on by
just pressing that Component Select button.
SET
SAT DVD TV CBL
TAPE CD VCR
1
VIDEO1
2
VIDEO2
3
AUX
4
TUNER
5
CD
6
TAPE
7
MD
8
TV
9
PHONO
0
DVD
GUIDE MENU
AMP
ENT
OK
1
-/--
ANALOG
DIGITAL
PROGRAM
1 2
1 2
1
Example: To clear the Power-on command
1
Press and while holding SET, press MENU.
SET
MENU
+
The SET indicator lights up.
SET
2
While holding 1 pressed, press the desired
Component Select button.
While the 1 button is pressed, the Component
Select buttons that Sony components are set to
flash in the following order.
TV
tDVDtSATtCBLtVCRtCDtTAPEtAMP
The Component Select buttons that Sony
components are not set to do not flash.