Sony RM-VL600T - Manual (Page 22)

22
Example: To programme the procedure above to
the SYSTEM CONTROL B button
1
Press and while holding SET, press the
SYSTEM CONTROL B button.
The SET indicator light turns on.
SET
If a System Control function (System Control
Macro) has already been set on the button,
the SET indicator flashes twice.
The setting procedure is automatically cancelled.
2
Set the System Control function.
With this example, press buttons in sequence as
below:
TV
1
VCR
VCR
AMP
VIDEO1
TV
1
1 1
You can programme up to 16 consecutive steps
on each of the SYSTEM CONTROL buttons (A –
D), including the initial step of pressing switch
to a Component Select button.
3
Press SET to complete the programming.
The SYSTEM CONTROL button light turns off.
To programme a new series of operations for
those buttons which already have a Control
Programme set
Erase the programme (page 22).
Notes
• If you interrupt the procedure at any point for over 20
seconds, the setting mode ends and the series of
commands will be programmed up to that point. In this
case, clear the programme (page 22) and start again from
Step 1 to set the entire programme from the beginning.
You cannot continue programming once the setting mode
ends.
• If a SYSTEM CONTROL button has already “learned” a
remote control signal (page 12), you can programme a
System Control function (System Control Macro), but the
function will not work until you clear the Learning
function. To clear the Learning function, see “Changing
or erasing the function of a “learned” button” on page
16.
• If you change the component code number (page 8) or
programme a new signal by using the Learning function
(page 12) on a key or a button that has been programmed
with a series of commands using the System Control
function, the new signal will be transmitted when you
press the corresponding SYSTEM CONTROL button.
• While in setting mode, you cannot clear any operation
step you have programmed. If you have programmed an
incorrect operation by mistake, start again from Step 1.
• If you try to programme more than 16 steps, the System
Control setting mode ends, and the 16 steps you have
programmed are registered. If you want to programme
the steps again, clear the programme (page 22) and start
again from Step 1.
Tips for programming the System Control
functions
The following information helps you to programme
a consecutive operation steps.
About the order of operation steps
Some of the components may not accept
consecutive remote control signals. For example,
some TVs generally may not respond to the next
signal right after the Power-on signal. So, a series of
commands such as TV Power-on and input select
may not work properly.
In this case, insert other signals to other
components, such as in the example below:
TV Power-on
tVCR Power-ont VCR playback t
TV input select
To clear programmed commands
1
Press and while holding SET, press and
hold for more than 3 seconds the SYSTEM
CONTROL button you want to clear.