Sony LMD-1420MD - Manual (Page 6)

Features
6
Features
The LMD-1420MD is a 14-type, LCD monitor.
Compliance with medical safety standards in
America, Canada and Europe
UL60601-1 for America, CSA C22.2 No.60601.1 for
Canada and EN 60601-1 for Europe have been obtained
for this monitor.
The monitor is designed for use in the medical treatment
field, with screen protect panel, etc.
High brightness LCD panel
Because of the monitor’s high brightness, high contrast
and wide viewing angle technology, it can be used under
various lighting conditions.
Rack mount monitors
The LMD-1420MD can be installed in a standard 19-
inch rack using an optional rack mounting bracket MB-
526.
Monitor stand with tilt function
As the stand with tilt function is equipped normally for
the monitor, you can use it easily on the desk top. When
you mount the monitor to the rack, remove the stand.
Tally lamp
The green LED lamp is used for the tally lamp. You can
check the status of the monitor, controlling the lamp
from the external remote.
Two color system available
The monitor can display NTSC and PAL signals by
connecting this unit.
Blue only mode
In the blue only mode, an apparent monochrome display
is obtained with all three of the R/G/B cathodes driven
with a blue signal. This facilitates color saturation and
phase adjustments and observation of VCR noise.
Analog RGB/component input connectors
Analog RGB or component signals from video
equipment can be input through these connectors.
Y/C input connectors
Y/C signals of the video signal can be input through this
connector.
SDI optional input
SDI signals can be available when SDI input adaptor
BKM-320D (optional) is attached.
External sync input
When the EXT SYNC button is in the on position, the
unit can be operated on the sync signal supplied from an
external sync generator.
Automatic termination (connector with
mark only)
The input connector is terminated internally at 75 ohms
when nothing has been connected to the output
connector. If a cable is connected to the output
connector, the internal terminal is automatically released
and the signals input to the input connector are output to
the output connector (loop-through).
Select color temperature and gamma mode
You can select the color temperature from among three
(high, low and low2) settings and gamma mode from
among five settings. You can also adjust the color
temperature to the appropriate setting.
Aspect setting
You can set the monitor to 4:3 or 16:9 display mode
according to the input video signal.
Scan setting
You can set the display size to -3% under scan or 5%
over scan mode.
Key inhibit function
You can inhibit a key, function to prevent misoperation.
Select language display
You can select from seven display languages English,
French, German, Spanish, Italian, Japanese and
Chinese.
External remote control function
You can directly select the input signal, aspect, etc., by
operating the equipment connected to the PARALLEL
REMOTE terminal.
Two kinds of ground terminals
Two kinds of ground terminals are built into the monitor
to equal the electric potential.