Sharp PG-D40W3D - Manual (Page 21)

17
Quick Start
1
Adjusting the focus.
2
Adjusting the height.
3
Adjusting the picture size.
4. Adjust the projected image
_P. 27
Correcting trapezoidal distortion using Keystone Correction.
On the projector
On the remote control
Shrinks
upper side.
Shrinks
lower side.
5. Correct trapezoidal distortion
_P. 28
Select the “COMPUTER1” using INPUT on the projector or COMPUTER1 on the remote
control.
On the
projector
On the remote
control
INPUT list
INPUT
COMPUTER1
COMPUTER2
HDMI H
1
2
On-screen display (RGB)
RGB
1024
× 768
COMPUTER1 1
When you press INPUT on the projector, the INPUT list appears.
Press '/" to switch the INPUT mode. •
6. Select the INPUT mode
_P. 29
7. Turn the computer on
Press STANDBY/ON on the projector or STANDBY on the remote control, and then press
the button again while the confi rmation message is displayed to put the projector into
standby mode.
On-screen display
On the
projector
On the remote
control
8. Turn the power off
_P. 26