Sony DVP-K360 - Manual (Page 9)

9
Getting Started
If you connect the player to a monitor or
projector having component video input
connectors that conform to output signals from
the COMPONENT VIDEO OUT (Y, C
B , C R ) connectors
on the player
Connect the component via the COMPONENT VIDEO
OUT connectors using three video connecting cords (not
supplied) of the same kind. You will get a better picture.
Notes
• Refer to the instructions supplied with the component to be
connected.
• Do not connect this player to a video deck. If you do, noise
may appear in the picture.
Connect
directly
VCR TV
CD/DVD
player
COMPONENT
Y
C B
C R
VIDEO IN
COMPONENT
Y
C B
C R
VIDEO OUT
CD/DVD player
Monitor or projector
with component video
input connectors
Setting the color system to your TV
The player’s color system must be set depending on the
TV to be connected.
• If the color system of the TV is NTSC or DUAL
Since the color system of the player is set to NTSC, you
can use the player as it is.
• If the color system of the TV is PAL
To change the color system of the player to PAL, hold
POWER down while pressing X on the player. The
power indicator lights up in green and changes to red.
Then release X.
z You can check the color system of the player
Press POWER on the player and then press @/1 on the remote.
The power indicator lights up in green. When “NTSC” appears
on the front panel display, the color system of the player is set to
NTSC. When “NTSC” does not appear, the color system is set to
PAL.