Sanyo PLC-XF1000 - Manual (Page 17)

17
Installation
Lens Installation
Before setting up the projector, install Projection Lens on the projector.
Before installation, check where the projector is used and prepare a suitable lens. For the specifications of
Projection Lens, contact sales dealer where you purchased the projector.
- Do not use the optional lens below for this projector . Otherwise damages may result .
LENS MODEL NO . : LNS-T01, LNS-T01Z
- Lens installation and replacement should be made by the qualified service personnel .
- When setting the projector after lens installation, be sure to replace a Lens Cap to protect a
surface.
- When carrying or holding up the projector, be careful not to put your hands on lens part. It may
damage lens, cabinet, or mechanical parts.
Installing the Strap for safety
Secure the lens mount cover and the projector with the
strap (supplied) to prevent the lens mount cover from
falling down.
Fig . 1
Screw A
Fig . 3
Label
Dot on the cabinet
Dot on the lens
mount cover
Strap
Remove the screw A. (See Fig. 1)
Turn the lens mount cover counter-clockwise and
take it off by pulling forward. (See Fig. 1)
1
2
Fit the raised dot of the lens mount cover to the
leftmost edge of the Label on the projector, and
then turn the lens mount cover clockwise and
adjust the position of the raised dot to the one of
the projector until it makes a clicking sound. (See
Fig. 3)
Put the strap through the hole of the lens mount
cover and fasten it firmly. (See Fig. 2)
3
5
Fig . 2
Strap
Lens Mount Cover
Screw A
Install the other end of the strap to the front of
the projector with screw A. (See Fig. 3)
4
✔
Note:
• The accessory screw (supplied) is not used for installation.
Lens Mount Cover
Hole