Sanyo PLC-XF1000 - Manual (Page 51)

51
Lamp control
Choose the running speed of cooling fans from the following
options.
Normal ....... Normal speed.
Max ........... Faster than the normal speed.
Fan control
This function allows you to change the brightness of the screen.
Auto . . . . . Brightness according to the input signal.
Normal . . . Normal brightness.
Eco . . . . . . Lower brightness. Lower brightness reduces
the lamp power consumption and extends the
lamp life.
Setting
This Projector is equipped with 2 Projection Lamps and the
number of using lamps can be switched to 2 lamps or 1 lamp.
Using 1 lamp maintains the life of Projection Lamps.
To change over Lamp Mode
Set "2 lamps mode" or "1 lamp mode" by pressing the Point 7 8
buttons. When the Lamp Mode is switched from "2 lamps mode"
to "1 lamp mode", the image becomes a little darker. When the
Lamp Mode is switched from "1 lamp mode" to "2 lamps mode",
the image becomes brighter gradually.
✔
Note:
• When neither of the two lamps is lighted, the
projector will shutdown automatically.
• When either of the two lamps does not light up,
the LAMP 1/2 REPLACE indicator blinks orange
and the projector will light the other automatically.
• After changing the Lamp Mode, it cannot be
switched again for 90 seconds.
Lamp mode
Filter control
You can replace the filter with this function. Press the SELECT
button at Filter control to display a confirmation box. To replace,
press the SELECT button at “YES” and the electrically operated
filter starts to scroll.
You can also replace the filter by using the remote control
(p. 30).
✔ Note:
• Filter replacement icon and “Please wait...”
message appear on the screen when the filter is
being scrolled.
• The filter cannot be rewound.
• When the filter is replaced, the total accumulated
time of the filter use is automatically set to 0.