Sony UP-DR150 - Manual (Page 17)

O
per
at
ion
Loading the Paper Roll and Ink Ribbon
17
Depending on the position of the break in the tape,
the ribbon for one sheet of printed paper may be
lost.
Note
If you turn the paper roll too far, too much paper
will be fed. This may cause the paper jamming.
Stop turning the paper roll right after the marking
hole turns blue.
Removing the Ink Ribbon and
Paper
When the error message “PAPER END” or “RIBBON
END” appears on the LCD, the paper or ink ribbon
corresponding to the designated number of sheets has
been used up.
Proceed as follows to remove the ink ribbon and paper
roll, and then load a new ink ribbon and paper roll.
1
Remove the scraps of paper ejected and
accumulated in the paper tray.
Note
If scraps of paper have accumulated in the paper
tray, the front door may not open completely.
Discard the scraps of paper ejected each time you
replace the ink ribbon and paper roll with new ones.
2
Open the front door.
Caution
Since the thermal head is still very hot just after
printing is finished, be careful not to touch the
thermal head when removing the ink ribbon and the
paper roll from the paper cartridge.
3
Push the right black spool to the left and pull it
toward you to remove the black spool of the ink
ribbon.
Do not re-use the removed ink ribbon.
4
Push the white spool to the left and pull it toward
you to remove the white spool of the ink ribbon.
Engage both white and black spools of the ink
ribbon.
5
Remove the paper.
1 Pull the ribbon base up.
2 Pull the paper holder of the printer toward you.
3 Turn both sides of the paper toward the inside
to wind the remaining paper.