Sony UP-DR150 - Manual (Page 18)

O
per
at
ion
Loading the Paper Roll and Ink Ribbon
18
4 Remove the paper roll.
5 Remove the pink paper holder from the paper.
6 Remove the blue paper holder.
Reuse the paper holders removed. Do not
discard them.
If you have to replace a partially used
printing pack
Do not replace the printing pack if it has only been
partially used. Return the paper roll and ink ribbon set to
their original packaging after they have been fully
consumed.
If you have to replace a partially used ink ribbon and
paper roll, proceed as follows to replace the partially
used ink ribbon and paper with new ones.
Note
If you change a partially used ink ribbon and paper, the
remaining amount of ink ribbon displayed may not be
correct.
1
Open the front door.
2
Pull the ribbon base up.
3
Pull the paper cartridge toward you, and remove the
paper.
4
Turn both ends of the paper toward the inside to
wind the remaining paper and attach a piece of tape
to prevent the paper from loosening.
5
Load the replacement paper roll.
6
Pull the ribbon base down. Remove the ink ribbon
and attach the ink ribbon that is paired with the
paper roll loaded in step 5.
7
Close the front door.
A certain amount of paper is automatically ejected
so that the paper where sweat or dirt from your
hands may have accumulated will be cut off.
Be sure to retain the removed paper roll and ink
ribbon as a pair.
Note
If you change ink ribbon and paper roll which have been
partially used, paper equal to several sheets are wasted
and you may not be able to print the number of sheets
specified.
For detailed information on the number of sheets that
can be printed, see “Printing capacity” on page 29.