Sony UP-DR150 - Manual (Page 27)

Mi
s
c
el
lane
ous
Precautions
27
Note
The surface of the rubber roller is soft and easily
scratched. When cleaning it, be careful not to scratch
and not to push on the surface of the rubber roller
strongly. Doing so may cause the picture quality of the
printouts to deteriorate.
When the following symptoms appear
When the message “HEAD IN COOLING”
begins to appear on the information display
frequently:
Ventilation holes are provided on the front and rear of
the printer. Clean the filter on the front panel of the
printer. If the filter is dirty, the time required for cooling
the thermal head is lengthened and this causes the
printing time to become longer.
1
Pull the lock lever for the front door toward you to
open the front cover.
2
Remove the filter.
3
Wash the filter with water to remove the dust.
Note
Do not rub the netting of the filter roughly.
4
After the filter has been dried completely, reset the
filter on the front panel as it was.
5
Close the front door by pushing it in the center part
of the front door.
Note
If you close the front door by pushing it on one side, the
front door may not be completely locked.
If white stripes or scratches appear on the
printout:
When you make printouts using the 2UPC-R153/
R153H/R155/R155H Printing Pack, after you have used
several rolls of the 2UPC-R154/R154H/R156/R156H
Printing Pack, the printout quality may deteriorate. For
example, white stripes or scratches may appear on the
printout.