Sony UP-DR150 - Manual (Page 8)

O
per
at
ion
Loading the Paper Roll and Ink Ribbon
8
Operation
Loading the Paper Roll
and Ink Ribbon
This section describes how to load the paper roll and ink
ribbon in the preparation to start printing, after
connecting the printer as described on page 6,
Notes
• Each printing pack contains two sets of the ink ribbon
and paper roll combination. Use the ink ribbon and the
paper roll in the carton as a set. Do not mix with other
varieties of ribbon or paper roll. (See “Ink Ribbon and
Paper” on page 29.)
• One set of the ink ribbon and paper roll allows you to
print the following number of sheets.
• Do not replace the printing pack if it has only been
partially used. The number of printouts that can be
printed may not be guaranteed if you replace the ink
ribbon and paper before they have run out.
• Place the paper roll vertically. If you place the paper
roll horizontally, the paper may roll around and fall.
This may cause an injury.
• Hold the paper roll with both hands so that you do not
drop it, because it is heavy. Dropping may result in an
injury.
• Do not detach the black and white spools of the ink
ribbon until you start loading the ink ribbon.
• A built-in IC chip is located around one side of the
black spool. Be careful not to remove the IC seal,
hurt it, or give it a shock. If you do, you may not be
able to use the ink ribbon any more.
Attaching the Paper Holders to the
Paper Roll
A pink paper holder and a blue paper holder are supplied
with the printer. Attach them to the new paper roll, and
then load the paper roll.
When you use the printer for the first time, start the
operation from step 1 to remove paper holders which
were placed in the printer at the factory.
If you have already removed the paper holders, start the
operation from step 4.
Print
pack 2UPC-
R153/
R153H 2UPC-
R154/
R154H 2UPC-
R155/
R155H 2UPC-
R156/
R156H
Printing
capacity 610 (sheets) 550 (sheets) 335 (sheets) 295
(sheets)
Print
size 89 × 127 mm 102 × 152
mm
127 × 178
mm
152×204
mm
3.5 × 5
inches
4 × 6 inches 5 × 7 inches 6 × 8
inches
Hold the paper roll with both hands.
White spool
Black spool
IC seal into which the IC
chip is built