To run the showcomponent command, To run the showcomponent, Table 2-7 – Sun Microsystems Sun Fire T1000 User Manual

Page 53

Advertising
background image

Chapter 2

Sun Fire T1000 Server Diagnostics

41

The ASR commands (

TABLE 2-7

) enable you to view, and manually add or remove

components from the ASR blacklist. These commands are run from the ALOM sc>
prompt.

Note –

The components (asrkeys) vary from system to system, depending on how

many cores and memory are present. Use the showcomponent command to see the
asrkeys

on a specific system.

Note –

A reset or powercycle is required after disabling or enabling a

component. If component status is changed with power on there is no effect to the
system until the next reset or powercycle.The following examples show the output
of these commands.

▼

To Run the showcomponent Command

The showcomponent command displays the system components (asrkeys) and
reports their status.

1. At the sc> prompt, enter the showcomponent command.

TABLE 2-7

ASR Commands

Command

Description

showcomponent

*

* The showcomponent command may not report all blacklisted DIMMs.

Displays system components and their current state.

enablecomponent

asrkey

Removes a component from the asr-db blacklist,
where asrkey is the component to enable.

disablecomponent

asrkey

Adds a component to the asr-db blacklist, where
asrkey is the component to disable.

clearasrdb

Removes all entries from the asr-db blacklist.

Advertising