Sun Microsystems Sun Fire T1000 - Manual (Page 76)

64 Sun Fire T1000 Server Service Manual • January 2006
▼ To Replace the Hard Drive
1. Unpackage the replacement hard drive and tray assembly.
2. Slide the hard drive and tray assembly into the chassis until it mates with the
front of the chassis ( FIGURE 3-10 ).
FIGURE 3-10 Replacing the Hard Drive
3. Snap the catches on the latches to lock the drive and tray assembly into place in
the chassis.
4. Redress the power and cable through the midwall in the chassis and reconnect the
cable to the rear of the drive.
5. Perform the procedures described in “Common Procedures for Finishing Up” on
page 72
6. Perform administrative tasks to reconfigure the hard disk drive.
The procedures that you perform at this point depend on how your data is
configured. You might need to partition the drive, create file systems, load data from
backups, or have it updated from a RAID configuration.
Example:
cfgadm -c configure c0t0d0s0C
Hard drive
Latches