To reinstall the server chassis in the rack, To apply power to the server – Sun Microsystems Sun Fire T1000 User Manual
Page 85
Advertising
Chapter 3
Removing and Replacing FRUs
73
▼
To Reinstall the Server Chassis in the Rack
Refer to the Sun Fire T1000 System Installation Manual for installation instructions.
After you have reinstalled the server chassis in the rack, reconnect all cables that you
disconnected when you remover the chassis from the rack.
▼
To Apply Power to the Server
1. Reconnect the power cord to the power supply.
Note –
As soon as the power cord is connected, standby power is applied.
Depending on the configuration of the firmware, the system might boot.
“Safety Information” on page 43
Advertising