Sony DVS-9000-C - Manual (Page 12)

1-4
DVS-9000/9000SF
1-4. Installing the Options
The DVS-9000-C/DVS9000SF-C is shipped from the
factory with the necessary option boards (refer to the
following table) already installed in accordance with the
specified system configuration.
The following options are available for the DVS-9000/
9000SF.
DVS-9000/9000SF Option List
Model name
Plug-in board Connector board
BKDS-9160 (DVS-9000 only) OUT-26 board CNO-19 board
24 Output Board
BKDS-9161 (DVS-9000 only) _ CNO-20 board
8 Monitor Output Board
BKDS-9162 (DVS-9000SF only) _ CNO-19 board
12 Output Board
BKDS-9210 MIX-46 board _
Mix/Effect Board
MKS-8110SD _ CNI-10 board
17 Input Board
MKS-8111SD (DVS-9000 only) _ CNI-17 board
Additional 12 Input Board
HK-PSU04 _ _
Power Supply Unit
1-4-1. Installing the Plug-in Boards
Each plug-in board of the Production Switcher Processor
DVS-9000/9000SF is allocated to a specific slot into which
they must be installed. Check to see that the respective
plug-in boards are installed in their respective slots.
The name of the board is shown near the eject lever at the
left-most end of each plug-in board.
Names of the plug-in boards and the slot numbers, to
which the plug-in boards are allocated, are shown on the
Extract PWB stopper assembly inside the front panel of the
DVS-9000/9000SF. Install the respective plug-in boards
according to this instruction.
n
Check to see that connectors of the plug-in boards are
securely inserted into the mother board (DVS-9000 : MB-
985 board, DVS-9000SF : MB-986 board) without loose
contact.
If any plug-in board is inserted into the incorrect slot, it
causes a system error and the system will not work correct-
ly.
c
Be sure to turn off the POWER switch before starting
installation work.
If installation work is started with the POWER switch left
on, it may cause electrical shock or damage to printed
circuit boards.
1-4. Installing the Options