Sony DVS-9000-C User Manual
Page 17
1-9
DVS-9000/9000SF
1-5. Rack Mounting
2. Rack Mounting Procedure
This section describes the rack mounting procedure using
the RMM-10 rack mount kit.
n
Tighten the screws to the following torque.
Tightening torque : 120
x 10
_2
N
.m {12.2 kgf.cm}
1.
Attach the rack tool to the side of the equipment using
the specified six screws.
n
Use B4
x 6 screws.
B4
x 6
B4
x 6
Rack tool
Rack tool
2.
Loosen the screws on the rear of the right and left
adapters and adjust the length of the adapter according
to the depth of the rack.
(The illustration below shows the left adapter.)
n
Maximum depth of adapter : 750 mm
Minimum depth of adapter : 595 mm
3.
Attach the right and left adapters to the rack complete-
ly using the specified six screws.
(The illustration below shows the left adapter.)
4.
Tighten the screws (B4
x 6 : two screws each on the
right and left) for adjusting the length of the adapter
completely (the screws that were loosened in step 2).
5.
Remove the front panel of the equipment.
(Refer to Section 1-4-1.)
B4
x 6
B4
x 6
Portion of
the rail
Adapter
B4
x 10
B4
x 10
31.75
31.75
1U
4U
8U
Unit : mm
(The illustration shows the DVS-9000.)