Sony IPELA NSR-100 - Manual (Page 180)

180
Miscellaneous
on the remote control unit will not change the layout. To change the layout,
select a monitor window with a camera assigned to it, and then press the [1×1]
button.
Remote Clients
• To connect to the NSR unit from RealShot Manager Controller, perform the
following steps after starting up RealShot Manager Controller.
1 Click [Remote Server].
2 Click [+] (Add).
3 Select “device type (Remote PC Interrogator),” enter the name, IP address,
and port number, and perform registration.
4 After registration is finished, click the [Remote PC] tab, and enter the
RealShot Manager connection user name and password for the NSR unit.
• In general, perform camera configurations from the NSR unit. When
performing, underscores (_), and hyphens (-) configurations from RealShot
Manager Controller, use only alphanumeric characters for settings such as the
name. Other characters can be registered, but they will not display properly.
• The addition, changing, or deletion of an audio device cannot be performed
from RealShot Manager Controller. Cameras and audio devices are registered
simultaneously under the same name on the NSR unit when necessary.
• When you register a camera supporting audio, an audio device is
automatically registered as well. As “Default” is automatically assigned as the
storage location for the audio device’s recordings during registration,
selecting “Default” as the storage location from RealShot Manager Controller
will cause the same device name to appear twice.
• When recording with the audio function enabled, two recordings (image and
audio) are created. You can differentiate between image and audio recordings
in the Search screen by filtering them.
• The addition, changing, and deletion of a storage location for recordings
cannot be performed from RealShot Manager Controller.
• The addition and deletion of cameras assigned to the motion detection pin
cannot be performed from RealShot Manager Controller.
• You cannot register a remote PC with the NSR from RealShot Manager
Controller.
• You cannot register the following devices from RealShot Manager Controller.
- SNT-V504
- SNC-VL10
- BarioNet
- Annuncicom
- Instreamer
• There are some settings that can be configured from RealShot Manager
Controller that cannot be configured (or displayed) on the NSR.
Examples:
- A clean up schedule set on RealShot Manager Controller will not appear on
the NSR.
- Audio output pins added on RealShot Manager Controller will not appear
on the NSR.
• You can select MPEG4-JPEG or JPEG-MEPG4 for the video codec of multi-
codec cameras such as the CS50 or RX550, but multiple error messages will
appear when you click [Apply]. Because the NSR does not use the alarm
buffer function, the multi-codec setting is not available on the NSR. The error
messages will not appear if you select a single codec setting (JPEG or
MPEG4).
• If you click an assigned camera under Object Detection Pin directly while
setting Object Detection for cameras from RealShot Manager Controller,
images from a different camera may be displayed, and RealShot Manager
Controller may abort in the middle of operations. If this occurs, click and