Sony DPP-FP55 - Manual (Page 18)

18 GB
Connecting a camera
or other external
device
To print an image from a camera or other
external device, connect it to the printer .
You can connect an external device that
supports mass storage system. For how to
connect the PictBridge-compliant digital
camera, see page 46.
Note
If a memory card is inserted in the printer,
the printer cannot read the signal from an
external device connected to the PictBridge
connector of the printer. Remove the memory
card, if any.
1
Set your digital camera or other
external device ready for printing
with the Mass Storage-compliant
printer.
The settings and operations that are
necessary before connection differ
depending on the external device you
use. For details, see the operating
instructions of the external device. (In
case of Sony Cyber-shot digital
camera, for example, select “Normal”
mode or “Mass Storage” mode for the
“USB Connect”. )
2
Connect a camera or an external
device to the PictBridge connector
of the printer.
Use the USB cable supplied with the
digital camera or other external
device.
Access indicator flashes
while the printer is
accessing the memory
card.
Insert it in the b
mark direction.
Inserting an SD card
Insert the SD card into the SD CARD slot
until it fits into place.
In the SD CARD slot of this printer, you
can use the following media;
• SD Memory card
• MiniSD card (you need to use a miniSD
card adaptor)
• MMC standard memory card
• RS-MMC card (you need to use an
MMC adaptor)
To eject an SD card
Push the SD card lightly into the insertion
slot. After it pops back out, remove it
slowly.
Notes
• When you remove the SD card, make sure to
hold it with your hands to prevent it from
popping out and hitting your eye, as this may
cause injuries.
• When you use a miniSD card, use a miniSD
card adaptor. If you insert a miniSD card
without the adaptor into a slot of the printer,
you may not be able to remove it.