Sherwood R-903R - Manual (Page 21)

21
• When selecting the front right distance mode,
“FRONT R 3.0 (m)”
• When selecting the center distance mode,
“CENTER 3.0 (m)”
• When selecting the surround left distance mode,
“SURR L 3.0 (m)”
• When selecting the surround right distance mode,
“SURR R 3.0 (m)”
• When selecting the Dolby Virtual delay time mode,
“NARROW”
• This mode can work only in the Dolby Virtual mode.
In the other surround modes, this setting is just
displayed.
• When selecting the crossover frequency setting
mode,
“CFREQ 80”
• You can adjust the distance within the range of 0.3
~ 9.0 meters in 0.3 meter interval.
Note:
• When the type of speaker is set to “N”, its distance
mode cannot be selected.
NARROW : Relatively long distance for the main
listening position to front speakers.
WIDE : Relatively short distance.
80 120 160 200
TURNING THE POWER ON/OFF
Operations
In the standby mode, turn the power on.
2
Press the POWER switch.
1
• This unit enters the standby mode.
The lighting of STANDBY indicator means that the
receiver is not disconnected from the AC mains and a
small amount of current is retained to support the
memorized contents and operation readiness.
• To switch the power off, push the POWER switch
again. Then the power is cut off and the STANDBY
indicator goes off.
• Each time the POWER button on the remote control
is pressed, the receiver is turned on to enter the
operating mode or off to enter the standby mode.
• In the standby mode, if the INPUT SELECTOR
button is pressed, the receiver is turned on
automatically and the desired input is selected.
POWER
ON/ OFF
• Note : Before operating this receiver with the supplied remote control, refer to “Universal Remote Controls” on page 10 for
details about operation.
Memory backup function
• These following items, set before the receiver is turned off, are memorized:
Input settings, surround mode settings, speaker settings, channel level settings, preset stations, etc.
(unit : Hz)
POWER
When the power operation switch is in the OFF or STANDBY state, the apparatus is still connected on
some AC line voltages.
Please be sure to unplug the cord when you leave home for, say, a vacation.
ENGLISH