Sherwood R-903R - Manual (Page 26)

26
Adjust the level of the selected channel
as desired. 2
Repeat the above steps 1 and 2 to adjust each
channel level.
3
Presetting and Calling the channel levels
Perform the steps 1 to 3 in “Adjusting
each channel level” on page 25~26 to
adjust each channel level you want.
1
SETUP
MEMORY
Press the SETUP button for more than 2
seconds, then it enters the setup mode. While
displaying the setup mode, press this button
short repeatedly until “P CALL” is displayed.
2
Confirm your decision. 4
ADJUST
TUNING/PRESET
”P CALL” : When calling the preset channel
levels.
“P MEMORY” : When storing the adjusted
channel levels in the preset
memory.
While displaying “P CALL”, select “P
MEMORY” with buttons below. 3
DECODING
TUNE MODE
• The adjusted channel levels has now been stored
in the preset memory.
• When using this function with remote control unit,
press OSD button and refer to page 38~40.
• If the channel display disappears, start from the
step 1 again.
• You can store the adjusted channel levels in the memory. If you change the channel levels and want to
hear with preset levels, you can call them again.
• Select “P CALL” with performing the above steps 2 to 4.
• Then the current channel levels are changed to the preset ones.
Presetting the channel levels
Calling the channel levels
CH/LEVEL
ENGLISH