Sherwood R-903R - Manual (Page 24)

24
ENGLISH
Signal format being input Selected decoding mode Selectable surround mode
Dolby Digital 5.1, IN-AUTO mode (DOLBY DIGITAL EX,) DOLBY DIGITAL,
Dolby Digital EX 6.1 channel sources DOLBY VIRTUAL
Dolby Digital 2-channel IN-AUTO mode (DOLBY DIGITAL EX,) PL II CINEMA, PL II
sources MUSIC, PRO LOGIC, DOLBY VIRTUAL
PCM(2 channel) sources IN-AUTO, IN-PCM mode PL II CINEMA, PL II MUSIC, PRO LOGIC,
Analog stereo sources DOLBY VIRTUAL, NEO 6 CINEMA, NEO 6
MUSIC, THEATER, MOVIE, HALL 1/2,
STADIUM, CHURCH, CLUB 1/2, ARENA 1/2,
GAME, MATRIX
DTS 5.1, IN-AUTO, IN-DTS mode (DTS ES DISCRETE/MATRIX)
DTS ES Discrete 6.1, DTS
DTS ES Matrix 6.1 sources
MPEG sources IN-AUTO mode corresponding MPEG surround mode
• You can also select the surround mode with using the buttons on the front panel.
(For details, refer to “SETTING UP THE SYSTEM ON FRONT PANEL” on page 44.)
ENJOYING SURROUND SOUND
Selecting the surround mode
• When the AUTO OSD function is on, the corresponding setup display is on the TV screen.
DSP
STEREO
• Each time the DSP MODE or button is pressed, the surround mode changes depending on the signal format
being input and the selected decoding mode as follows :
( ): possible only when surround back speaker setting is not “N”.
• When 96 kHz PCM signals are input, the stereo mode is selected automatically; the surround mode cannot be selected.
• When MPEG signals are input in the IN-AUTO mode, the corresponding MPEG surround mode will be selected
regardless of using the DSP MODE or button.
Notes:
• When the selected decoding mode is not matched to the input signal format, the “DIGITAL” indicator flickers and
no sound is heard. Therefore, be sure to select the required decoding mode and the available surround mode
according to the input signal format.
• When the 7 CH DIRECT is selected as an input source, the decoding and surround modes cannot be selected.
• When the digital signals are not input, the desired surround mode cannot be selected.
• When the headphone is used, the surround mode cannot be selected.
To cancel the surround mode for stereo operation
• Then the stereo mode is selected.
• To cancel the stereo mode, select the desired surround
mode with using the DSP MODE or button.