Sherwood R-903R - Manual (Page 25)

25
FL C FR SR
SW SL SB
Front Left Center Front Right Surround
Right
Subwoofer Surround Surround
Left Back
At each channel, adjust the level so that
they are all heard at the same level. 2 Cancel the test tone function. 3
• You can adjust the level of test tone for each channel so that they are all heard at the same level.
Note : When the 7 CH DIRECT is selected as an input source or the headphones are plugged, the test tone function does
not work.
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to
suit your tastes.
• You can also adjust the channel levels with using the buttons on the front panel.
(For details, refer to “SETTING UP THE SYSTEM ON FRONT PANEL” on page 43.)
Adjusting each channel level with test tone
Enter the test tone mode. 1
• The test tone will be heard from the speaker of each
channel for 2 seconds as follows:
FL C FR SR
SW SL SB
• When the speaker setting is “N”, the test tone of the
corresponding channel is not available.
Front Left Center Front Right Surround
Right
Subwoofer Surround Surround
Left Back
• You can select the desired channel and adjust its level
with repeating the steps 1 and 2 in “Adjusting each
channel level” procedure.
Adjusting each channel level
Select the desired channel. 1
• When it is in the stereo or Dolby Virtual mode or the speaker setting is “N”, center, surround
L/R, surround back or subwoofer channel will not be selected.
• When the headphones are plugged, only the front L/R channel can be selected.
• Each time this button is pressed, the
corresponding channel is selected and
displayed for several seconds as follows:
T.TONE
CH/LEVEL
T.TONE
CH.SEL
ENGLISH